Прирачник Whirlpool W2F HD624 Машина за миење садови

Ви треба прирачник за вашиот Whirlpool W2F HD624 Машина за миење садови? Подолу можете да го погледнете и преземете PDF прирачникот бесплатно на англиски јазик. Овој производ моментално има 0 често поставувани прашања, 1 коментар и има 5 гласови со просечна оцена на производот од 80/100. Ако ова не е прирачникот што го сакате, ве молиме контактирајте со нас.

Дали вашиот производ е дефектен и прирачникот не ви нуди решение? Одете во Repair Café за бесплатни услуги за поправка.

Прирачник

2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately 1
kg); it is not unusual for a little water to leak out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory sets the default value for the water hardness.
Switch on the appliance by pressing the ON/OFF button.
Switch o the appliance by pressing the ON/OFF button.
Hold down button START/Pause for 5 seconds, until you hear a beep.
Switch on the appliance by pressing the ON/OFF button.
The current selection level number and the salt indicator light both ash.
Press button P to select the desired hardness level (see WATER HARD-
NESS TABLE).
Switch o the appliance by pressing the ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher deter-
gent.
Water Hardness Table
Level
°dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be
lled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
Switch the dishwasher on using the ON/OFF button.
Switch it o using the ON/OFF button.
Press button START/Pause three times - a beep will be heard.
Switch it on using the ON/OFF button.
The current selection level number and rinse aid indicator light ash.
Press button P to select the level of rinse aid quantity to be supplied.
Switch it o using the ON/OFF button
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
If you see bluish streaks on the dishes, set a low number (2-3).
If there are drops of water or limescale marks on the dishes, set a
mid-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser D there are indi-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
C
D
Преземете прирачник на англиски јазик (PDF, 93.49 MB)
(Размислете за животната средина и отпечатете го овој прирачник само ако е навистина неопходно)

Оцена

Кажете ни го вашето мислење за Whirlpool W2F HD624 Машина за миење садови, така што ќе го оцените производот. Сакате ли да го споделите вашето искуство со овој производ или да поставите прашање? Оставете коментар во долниот дел на страницата.
Дали сте задоволни со Whirlpool W2F HD624 Машина за миење садови?
Да Не
80%
20%
5 гласови

Приклучете се во разговорот за овој производ

Тука можете да го споделите вашето мислење за Whirlpool W2F HD624 Машина за миење садови. Ако имате прашања, најпрво прочитајте го прирачникот. Можете да побарате прирачник ако го употребите нашиот прирачник за контакт.

Galambos Márton 03-07-2025
Добредојдовте! Whirlpool W2FHD624 машина за миење садови би сакал да преземам упатства за унгарска употреба, но за жал не дозволува

одговор | Ова беше корисно (0) (Преведено од Google)

Повеќе за овој прирачник

Разбираме дека е практично да имате печатен прирачник за Whirlpool W2F HD624 Машина за миење садови. Секогаш можете да го преземете прирачникот од нашата интернет-страница и да го отпечатите сами. Ако сакате да го имате оригиналниот прирачник, ви препорачуваме да контактирате со Whirlpool. Тие можеби ќе можат да ви дадат оригинален прирачник. Барате прирачник за вашите Whirlpool W2F HD624 Машина за миење садови на различен јазик? Изберете го претпочитаниот јазик на нашата интернет-страница и пребарајте го бројот на модел за да видите дали го имаме.

Спецификации

Бренд Whirlpool
Модел W2F HD624
Категорија Машини за перење садови
Тип датотека PDF
Големина на датотека 93.49 MB

Сите прирачници за Whirlpool Машини за перење садови
Повеќе прирачници за Машини за перење садови

Прирачник Whirlpool W2F HD624 Машина за миење садови

Поврзани производи

Поврзани категории

×
Download