Прирачник Tesla IR510GR Пегла
Ви треба прирачник за вашиот Tesla IR510GR Пегла? Подолу можете да го погледнете и преземете PDF прирачникот бесплатно на англиски јазик. Овој производ моментално има 0 често поставувани прашања, 0 коментари и има 0 гласови. Ако ова не е прирачникот што го сакате, ве молиме контактирајте со нас.
Дали вашиот производ е дефектен и прирачникот не ви нуди решение? Одете во Repair Café за бесплатни услуги за поправка.
Прирачник
3
How to fill with water
Make sure the iron is turned off and the power cord is
unplugged from the electrical outlet.
1. Set the ‘Variable’ steam knob to the ‘0’ position before
filling the iron with water.
2. Open the ‘Water Fill’ Opening and fill the Tank up to
the ‘MAX’ Line on the tank.
3. The water level can be observed through the
transparent part of the tank, when iron placed vertically,
in case of water level becomes low, refill the tank,
following the procedure described in steps 1 to 3
above.
4. Pour out the remaining water after use.
NOTE
Most tap water can be used in this iron. Do not use water
additives or substitute water such as linen or scented water
in the steam iron, they can stain fabrics or damage the iron.
Do not fill the water more than the ‘MAX’ position.
How to use as dry iron
1. Position the iron vertically.
2. Plug the iton.
3. Set the Temperature Control Dial to ‘MIN’ position.
4. Preheat the iron until the indicator light goes out.
Now dry ironing can begin.
How to use the spray
Before using the spray feature, check the fabric label for
ironing instructions because some fabrics may be spotted
or stained with moisture.
The spray feature is particularly helpful for removing
stubborn wrinkles and where extra dampening is needed.
The spray may be use with steam or dry ironing. Simply
pump the Spray Mist knob when spray is desired.
How to use as steam iron
Fill the iron as described in ‘ How to fill with water’.
1. Position the iron vertically and turn the Temperature
Control Dial to the steam position.
2. Plug the Cord into the electrical outlet.
3. Set the Temperature Control Dial to the steam
position. Steam Ironing is only possible when at higher
temperature settings indicated with ‘MAX’ mark;
otherwise the water will leak from the soleplate.
4. Preheat the iron until the indicator light goes out. The
light will turn off when the indicated setting reaches the
correct temperature.
5. Turn the Variable Steam Control Knob to the required
setting for different types of fabric.
Now steam ironing can begin.
How to use the burst of steam
The burst of steam feature provides additional steam for
removing stubbom wrinkles. It may be used with steam or
fry ironing.
Press the Power Steam button to release the surge of steam.
Pressing the button several times may be necessary to
prime the surge system. Wait a few seconds for the steam
to penetrate the fabric before pressing the button again for
more steam.
NOTE
For optimum steam quality, do not apply more than three
successive shots after the indicator light goes off.
Anti-Calc Function
The anti-calc function is a permanet system loacated inside
the water tank to eliminate impurities from the water and to
reduce the problems connected with limescale build-up.
To prolong the efficiency of this system, follow these steps
occasionally:
1. Unplug the iron and allow it to cool down.
2. Locate the water cup that accompanied the iron. Fill it
with water 3/4 full. Add 1 teaspoon of salt to water and
fill the water tank with this solution.
3. Leave the solution in the water tank for 15 minites,
shaking occasionally, and then empty it.
4. Fill the water tank a second time with salt water
solution, shaking occasionally and empty it again after
15 minites.
5. Fill the tank with fresh water to rinse and empty.
Anti-Drip Function
This system controls the water flow to the soleplate at all
times. Below a certain temperature, the anti-drip function
cuts off the flow of water and stops the iron from dripping
onto the fabric.
After each use
1. Turn the iron off and unplug.
2. Empty the iron immediately after using. Do not store
the iron with water in it.
3. Wait until the iron has cooled before storing it, and
always set it on the Hell Rest to protect the soleplate
from scratches, corrosion or stains.
4. After letting iron cool down completely, store the iron
vertically in a safe place.
Outside surface of the iron
After unplugging and cooling the iron, simply wipe off with
a damp cloth and if necessary, use a mild detergent. NEVER
USE ANY HARSH CLEANERS.
Преземете прирачник на англиски јазик (PDF, 1.56 MB)
(Размислете за животната средина и отпечатете го овој прирачник само ако е навистина неопходно)
Оцена
Кажете ни го вашето мислење за Tesla IR510GR Пегла, така што ќе го оцените производот. Сакате ли да го споделите вашето искуство со овој производ или да поставите прашање? Оставете коментар во долниот дел на страницата.Повеќе за овој прирачник
Разбираме дека е практично да имате печатен прирачник за Tesla IR510GR Пегла. Секогаш можете да го преземете прирачникот од нашата интернет-страница и да го отпечатите сами. Ако сакате да го имате оригиналниот прирачник, ви препорачуваме да контактирате со Tesla. Тие можеби ќе можат да ви дадат оригинален прирачник. Барате прирачник за вашите Tesla IR510GR Пегла на различен јазик? Изберете го претпочитаниот јазик на нашата интернет-страница и пребарајте го бројот на модел за да видите дали го имаме.
Спецификации
| Бренд | Tesla |
| Модел | IR510GR |
| Категорија | Пегли |
| Тип датотека | |
| Големина на датотека | 1.56 MB |
Сите прирачници за Tesla Пегли
Повеќе прирачници за Пегли
Приклучете се во разговорот за овој производ
Тука можете да го споделите вашето мислење за Tesla IR510GR Пегла. Ако имате прашања, најпрво прочитајте го прирачникот. Можете да побарате прирачник ако го употребите нашиот прирачник за контакт.